Horizontal Band Saws
Horizontal Band Saw Safety
What should you do before using a cold metal saw?
Metal saws can be dangerous if not used properly.
- Read the owner’s manual carefully.
- Make sure you understand instructions and are properly trained before operating a metal saw. Refer to OSH Answers Metalworking Machines – General for general safety tips.
Cold cutting saws include hand and powered hacksaws, band saws, and horizontal and vertical circular saws.
What are some basic safety principles to follow?
- Wear appropriate safety glasses.
- Ensure the saw has a start/stop button within easy reach of the operator.
- Ensure that all guards are in place and working properly.
- Guard long material at both ends to prevent anyone from coming into contact with it.
- Ensure that the blade is completely stopped before removing the stock.
- Use cutting or lubricating fluid when cutting metals.
- Keep saw blades clean and sharp. Check blades regularly for wear or damage.
- Select the correct blade and saw speed for the material being cut. Follow the manufacturer’s instructions.
- Use the stop gauge supplied with most cut-off saws when several pieces of the same length are required.
- Secure all work in a vise. Place the section to be cut such that the saw blade will clear the vise and table; however, do not place the section so far away from the vise that it will be unstable when being cut.
- Support long stock with a floor stand.
- Keep working surface clean of scraps, tools, and materials.
- Keep the floor around saw free of oil, grease, and debris.
What should you avoid doing?
- Do not place, measure or remove work unless the saw is stopped.
- Do not apply extra force to the saw blade.
- Do not leave saw running unattended.
Document last updated on January 2, 2012.
The original source of this information is from the Canadian Centre for Occupational Health and Safety www.ccohs.ca. All rights reserved.